logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Machine Design Comments

  • Question
  • A transmission shaft includes


  • Options
  • A. counter shaft
  • B. line shaft
  • C. over head shaft
  • D. all of these

  • Correct Answer
  • all of these 


  • Machine Design problems


    Search Results


    • 1. An open belt drive is used when

    • Options
    • A. shafts are arranged parallel and rotate in the opposite directions
    • B. shafts are arranged parallel and rotate in the same directions
    • C. shafts are arranged at right angles and rotate in one definite direction
    • D. driven shaft is to be started or stopped whenever desired without interferring with the driving shaft
    • Discuss
    • 2. Screws used for power transmission should have

    • Options
    • A. Low efficiency
    • B. high efficiency
    • C. very fine threads
    • D. strong teeth
    • Discuss
    • 3. Slenderness ratio is the ratio of

    • Options
    • A. maximum size of column to minimum size of column
    • B. width of column to depth of column
    • C. effective length of column to least radius of gyration of the column
    • D. effective length of column to width of column
    • Discuss
    • 4. Which of the following statement is correct for gears?

    • Options
    • A. The addendum is less than dedendum
    • B. The pitch circle diameter is equal to the product of module and number of teeth
    • C. The pitch circle is always greater than the base circle
    • D. all of the above
    • Discuss
    • 5. According to I.B.R., shearing resistance required to shear off the rivet per pitch length (in double shear) is (where n = Number of rivets per pitch length)

    • Options
    • A. d2 x ? x n
    • B. 1.875 x d2 x ? x n
    • C. 2 x d2 x ? x n
    • D. 3 x d2x ? x n
    • Discuss
    • 6. In order to obtain the bolts of uniform strength, an axial hole is drilled through the head as far as the threaded portion such that the area of shank becomes equal to the root area of the thread.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. According to Guest's theory, the failure occurs at a point in a member when the maximum shear stress in a bi-axial stress system reaches the shear stress at elastic limit in simple tension test.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. Circumferential joint in boilers is used to get the required length of a boiler.

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. Surface endurance limit of gear material is dependent upon its

    • Options
    • A. elastic strength
    • B. yield strength
    • C. brinell hardness number
    • D. toughness
    • Discuss
    • 10. The load cup of a screw jack is made separate from the head of the spindle to

    • Options
    • A. enhance the load carrying capacity of the jack
    • B. reduce the effort needed for lifting the working load
    • C. prevent the rotation of load being lifted
    • D. reduce the value of frictional torque
    • Discuss


    Comments

    There are no comments.

Enter a new Comment