Which of the following planets of our solar system has least mass?

Correct Answer: Proxima Centauri

Explanation:

Proxima Centauri is the nearest star, and on August 24, 2016 astronomers announced it likely has a planet. This star is the nearest of a triple star system, which we on Earth see with the eye alone as the single star Alpha Centauri, visible from Earth's Southern Hemisphere

Correct Answer: banking of roads

Correct Answer: Metamorphic

Correct Answer: centrifugation

Explanation:

Sometimes the solid particles in a liquid are very small and can pass through a filter paper. For such particles, the filtration technique cannot be used for separation. Such mixtures are separated by centrifugation.

Correct Answer: Wind gap

Explanation:

Demoiselles

These are rock pillars which stand as resistant rocks above soft rocks as a result of differential erosion of hard and soft rocks.

Zeugen

A table-shaped area of rock found in arid and semi-arid areas formed when more resistant rock is reduced at a slower rate than softer rocks around it.

A Dreikanter

It is a type of ventifact that typically forms in desert or periglacial environments due to the abrasive action of blowing sand.

A wind gap is a gap through which a waterway once flowed that is now dry as a result of stream capture.

Correct Answer: Himachal Pradesh

Explanation:

Presently, there are 226 flood forecasting stations consisting of 166 level forecasting stations for villages and towns and 60 inflow forecasting stations for reservoirs/dams/barrages in the country. Existing flood forecasting network covers 22 States / Union Territories and 19 major river basins / sub-basins in the country.

Correct Answer: Thermosetting

Explanation:

Thermoset, or thermosetting, plastics are synthetic materials that strengthen during being heated, but cannot be successfully remouldedor reheated after their initial heat-forming. This contrasts withthermoplastics, which soften when heated and harden and strengthen after cooling. Thermoplastics can be heated, shaped and cooled as often as necessary without causing a chemical change, while thermosetting plastics will burn when heated after the initial moulding.

Correct Answer: Trapping of solar energy due to atmospheric gases

Correct Answer: Both the statements are individually true but Statement II is not the correct explanation of Statement I

Explanation:

A sinkhole (in Karst topography) is a hole in the ground that forms when water dissolves surface rock. Often, this surface rock is limestone, which is easily eroded, or worn away, by the movement of water.

Formation of a Sinkhole: In a landscape where limestone sits underneath the soil, water from rainfall collects in cracks in the stone. These cracks are called joints. Slowly, as the limestone dissolves and is carried away, the joints widen until the ground above them becomes unstable and collapses. The collapse often happens very suddenly and without very much warning. Water collects in these collapsed sections, forming sinkholes.

Sinkholes also form when the roofs of caves collapse. Sinkholes are often funnel-shaped, with the wide end open at the surface and the narrow end at the bottom of the pool.Sinkholes vary from shallow holes about 1 meter (3 feet) deep, to pits more than 50 meters (165 feet) deep.

Correct Answer: Statement I is false but Statement II is true  

Explanation:

Rejuvenation occurs when the river?s base level falls (i.e. when sea level falls). This can be a consequence of either a fall in the amount of sea water or the land rising. Incised meanders are meanders which are particularly well developed and occur when a river?s base level has fallen giving the river a large amount of vertical erosion power, allowing it to down cut. Hence, 2nd statement is correct.

There are two types of incised meanders, entrenched meanders and ingrown meanders.As they are products of rejuvenation, they are not formed in mature stage of a river