Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Digital Electronics
»
Interfacing to the Analog World
A counter-ramp ADC stops counting when ________.
the input voltage equals the DAC staircase voltage
the counter reaches a maximum count
the input voltage equals 5 volts
the DAC staircase voltage equals 5 volts
Correct Answer:
the input voltage equals the DAC staircase voltage
← Previous Question
Next Question→
More Questions from
Interfacing to the Analog World
The main advantage of the tracking A/D converter over the stairstep-ramp A/D converter is that ________.
The circuit shown below is a(n) ________.
The number of binary bits at the input of a DAC or the output of an ADC is known as ________.
The output of the circuit in the given figure (a) at point X on figure (b) will be ________.
________ ADCs have a fixed value of conversion time that is not dependent on the value of the analog input.
A signal ________ is produced by sampling the signal at a rate less than the minimum rate identified by Nyquist.
The fastest analog-to-digital converter is the ________.
A binary-weighter resistor DAC is practical only up to a resolution of ________.
The primary disadvantage of the simultaneous A/D converter is ________.
When analog inputs from several sources are to be converted, a(n) ________ technique can be used.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments