Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Digital Electronics
»
Integrated Circuit Technologies
If ICCH is specified as 1.1 mA when VCC is 5 V and if the gate is in a static (noncharging) HIGH output state, the power dissipation (PD) of the gate is ________.
5.5 mW
5.5 W
5 mW
1.1 mW
Correct Answer:
5.5 mW
← Previous Question
Next Question→
More Questions from
Integrated Circuit Technologies
Which is not a precaution for handling CMOS?
Unused TTL inputs should be tied LOW.
There are four different logic level ranges for TTL and CMOS: VIL, VIH, VOL, and VOH.
ECL IC technology is faster than TTL technology.
The speed-power product provides a basis for the comparison of logic circuits when power dissipation and propagation delay are important considerations in the selection of the type of logic to be used.
A pull-down resistor must be used with open-collector TTL circuits.
Power dissipation is a measure of a circuit's noise immunity.
CMOS is a more dominant IC technology than TTL.
The total sink current decreases with an increase in each load gate input.
The greater the propagation delay, the higher the maximum frequency.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments