Curioustab

Home » Digital Electronics » Flip-Flops

When using edge-triggered flip-flops, the data is entered into the flip-flop on the leading edge of the clock, but the output does not change until the trailing edge of the clock.

True

Correct Answer: False

← Previous Question Next Question→

More Questions from Flip-Flops

In VHDL, each instance of a component is given a name followed by a semicolon and the name of the library primitive.
PRESET and CLEAR inputs are normally synchronous.
Edge-triggered flip-flops can be identified by the triangle on the clock input.
A J-K flip-flop and associated waveforms are shown below. The circuit is operating properly.
A D-type latch is able to change states and "follow" the D input regardless of the level of the ENABLE input.
A negative edge-triggered flip-flop will accept inputs only when the clock is LOW.
Latches are tristate devices whose state normally depends on asynchronous inputs.
The term CLEAR always means that .
Parallel data transfers between two different sets of registers require more than one shift pulse.
The J-K flip-flop is a standard building block of clocked (sequential) logic circuits known as logic standard primitives.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion