Curioustab

Home » Digital Electronics » Digital System Projects Using HDL

In the digital clock project HDL code, the MOD-12 counter is using ________.

a BCD counter followed by a MOD-2 counter
a single HDL module
a MOD-6 counter followed by a MOD-2 counter
a MOD-12 counter followed by a D flip-flop

Correct Answer: a single HDL module

← Previous Question Next Question→

More Questions from Digital System Projects Using HDL

In the digital clock project, when it is 11:59:59, AND gate 1 detects that the tens of hours is 1 and the enable input is active. On the next clock pulse the AM/PM flip-flop will ________.
In the stepper motor, the half-step sequence is used when ________.
VARIABLES are considered to be updated ________ within a sequence of statements in a PROCESS, whereas SIGNALS referred to in a PROCESS are updated when the PROCESS ________.
One of the first steps in small-project management is to determine ________.
The step rate of the simulation of a stepper motor is probably ________ the actual stepper motor.
In the keypad encoder, the ring counter is implemented using ________ that responds to the clk input.
The timing and control block provides the ________ for the frequency counter.
Using one case construct inside another is known as ________.
In the digital clock project, the 60 Hz signal is sent through a Schmitt-trigger circuit to produce square pulses at the rate of ________.
In the keypad encoder, the ________ activate(s) the freeze bit only when one column is low.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion