Curioustab

Home » Digital Electronics » Digital System Projects Using HDL

In the stepper motor, the half-step sequence is used when ________.

less torque is needed
larger steps are desired
smaller steps are desirable
more torque is needed

Correct Answer: smaller steps are desirable

← Previous Question Next Question→

More Questions from Digital System Projects Using HDL

VARIABLES are considered to be updated ________ within a sequence of statements in a PROCESS, whereas SIGNALS referred to in a PROCESS are updated when the PROCESS ________.
One of the first steps in small-project management is to determine ________.
The step rate of the simulation of a stepper motor is probably ________ the actual stepper motor.
In the keypad encoder, the ring counter is implemented using ________ that responds to the clk input.
The timing and control block provides the ________ for the frequency counter.
Using one case construct inside another is known as ________.
In the digital clock project, the 60 Hz signal is sent through a Schmitt-trigger circuit to produce square pulses at the rate of ________.
In the keypad encoder, the ________ activate(s) the freeze bit only when one column is low.
A very critical dimension in project management is ________.
The interface of the stepper motor needs to operate in one of ________ mode(s).

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion