Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Computer Science
»
Disk Operating System (DOS)
The MODE command of MS-DOS is used to
display information about several types of devices installed in your computer
provide various types of control over your printers
make changes of the current display
All of the above
None of the above
Correct Answer:
All of the above
← Previous Question
Next Question→
More Questions from
Disk Operating System (DOS)
Using the _____ switch causes FDISK to display the partition status of your hard disk without executing FDISK.
Upper Memory blocks are located where?
What is a TSR?
What file contains commands that configure systems devices?
After upgrading your computer to a new DOS version, an older application displays the error message "Incorrect DOS version". What should you do to run this application?
In DOS, what key would you press to step through the Config.sys and Autoexec.bat?
To view any currently running Terminate Stay Resident (TSR's) programs you could type:
HIMEM.SYS controls:
Which command is used to delete the directory and all its contents in one step?
Which of the following applies to Internal DOS commands?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments