Curioustab

Home » Computer Science » Disk Operating System (DOS)

In DOS, which of the following keys will bypass the CONFIG.SYS and AUTOEXEC.BAT files?

F8
F5
F4
Fl
None of the above

Correct Answer: F5

← Previous Question Next Question→

More Questions from Disk Operating System (DOS)

After doing a low-level format, what would be the next step in configuring the hard drive in a system?
When executed from a bootable hard drive, which command will make a formatted floppy disk bootable?
After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
While working with MS-DOS, which command is used to restore files that were backed up using the BACKUP command?
The MODE command of MS-DOS is used to
Using the _____ switch causes FDISK to display the partition status of your hard disk without executing FDISK.
Upper Memory blocks are located where?
What is a TSR?
What file contains commands that configure systems devices?
After upgrading your computer to a new DOS version, an older application displays the error message "Incorrect DOS version". What should you do to run this application?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion