Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Home
»
Computer Science
»
Computer Hardware
What is the first step in diagnosing a completely dead computer at the client site that was working the day before.
Test the power supply
replace the CMOS battery
check the AC outlet
reseat the hard drive controller cable
None of the above
Correct Answer:
check the AC outlet
← Previous Question
Next Question→
More Questions from
Computer Hardware
You can have EISA and MCA devices in the same PC.
Which of the following items would require you to comply with EPA disposal guidelines?
What device protects against line deficiencies?
_____ is the term used to refer to the process of two modems establishing communications with each other.
Capacitance is measured in units of:
A capacitor is measured in which of the following units?
What expansion types do most pll/plll motherboards support?
You are testing the resistance in Ohms of a fuse on a 15K amp system. If the fuse is good, the meter should read?
After installing a sound card, the system locks up when a parallel port tape backup unit is also used. What is most likely the problem?
Modems use transmission.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments