Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Computer Science
»
Computer Hardware
To install a second IDE drive into a computer, you must:
Set the master-slave jumper to slave on the second drive
Use the IDE configuration software to set the new drive as slave
Verify that you define the new drive as D: in the CMOS setup
Verify that you attach the drive to the connector at the end of the ribbon cable
None of the above
Correct Answer:
Set the master-slave jumper to slave on the second drive
← Previous Question
Next Question→
More Questions from
Computer Hardware
Which of the following FRUs would be considered both an input/output device?
What is the most significant difference between the USB and IEEE1394 standards?
Which should you use for cleaning Mylar-protected LCD screens?
When is the risk for electrostatic discharge the greatest?
You have a PC with no video* Which of the following is LEAST likely to be causing the problem?
What device prevents power interruptions, resulting in corrupted data?
After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
Which would you do first when troubleshooting a faulty monitor?
What could cause a fixed disk error?
SCSI must be terminated with?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments