Curioustab

Home » Civil Engineering » Water Resources Engineering

The form factor of a drainage basin is obtained by dividing

area of the basin by the axial length
average width of the basin by the axial basin
area of the basin by the square of the axial length
both (a) an (b)
both (b) and (c).

Correct Answer: both (b) and (c).

← Previous Question Next Question→

More Questions from Water Resources Engineering

The specifications of most commonly used standard gauges in India, are
The formula for calculating the overland flow time (To) in hours for any basin, is (where Lo is the distance of the critical point and H is the difference in elevation)
Pick up correct statement from the following :
The elevation Z of the watershed is : (where letters carry their usual meanings)
Pick up the correct statement from the following :
When a constant discharge 2.91 litres/sec. was obtained in a pumping test, the draw downs in the test wells at 3 m and 6.184 m were 2.6 m and 0.3 m respectively. If over-all depth of the pumping well was 16 m, the permeability of the soil, is
A volume of air at constant barometric pressure may be brought to dew point by
Levees and flood walls,
Pick up the correct statement from the following :
Pick up the correct statement from the following :

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion