Curioustab

Home » Civil Engineering » Strength of Materials

A diagram which shows the variations of the axial load for all sections of the span of a beam, is called

bending moment diagram
shear force diagram
thrust diagram
stress diagram
none of these.

Correct Answer: thrust diagram

← Previous Question Next Question→

More Questions from Strength of Materials

The stress in the wall of a cylinder in a direction normal to its longitudinal axis, due to a force acting along the circumference, is known as
A simply supported beam carries two equal concentrated loads W at distances L/3 from either support. The maximum bending moment
Maximum deflection of a cantilever due to pure bending moment M at its free end, is
Euler's formula states that the buckling load P for a column of length l, both ends hinged and whose least moment of inertia and modulus of elasticity of the material of the column are I and E respectively, is given by the relation
In the given below figure, the rivets with maximum stress, are :
If a solid shaft is subjected to a torque T at its end such that maximum shear stress does not exceed fz the diameter of the shaft will be
In a square beam loaded longitudinally, shear develops
A member which is subjected to reversible tensile or compressive stress may fail at a stress lower than the ultimate stress of the material. This property of metal, is called
A cantilever carries is uniformly distributed load W over its whole length and a force W acts at its free end upward. The net deflection of the free end will be
Pick up the correct statement from the following :

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion