Curioustab

Home » Civil Engineering » Steel Structure Design

On steel structures the dead load is the weight of

steel work
material fastened to steel work
material supported permanently
all the above.

Correct Answer: all the above.

← Previous Question Next Question→

More Questions from Steel Structure Design

According to IS: 800-1962, the coefficient of expansion of steel per degree centigrade per unit length, is taken as
The minimum width B of a solid casing for a cased beam, is equal to
Modified moment of inertia of sections with a single web, is equal to moment of inertia of the section about Y-Y axis at the point of maximum bending moment and is multiplied by the ratio of
Rolled steel beams are :
The effective length of a compression member of length L held in position at both ends but not restrained in direction, is
When the ratio of the moment M to axial load P is greater than, the resultant of the compressive bearing pressure which acts at a distance Y from one side, is given by
Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed
A web plate is called unstiffened if the ratio of clear depth to thickness is less than
If the thickness of a structural member is small as compared to its length and width, it is classified as
If R is the reaction on the bearing plate, the minimum moment of. inertia of the bearing stiffener provided at the support of a plate girder of overall depth D, the maximum thickness of the compression flange T, carrying total load W, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion