Curioustab

Home » Civil Engineering » GATE Exam Questions

The standard plate size in a plate bearing test for finding modulus of subgrade reaction (k) value is

100 cm diameter.
50 cm diameter.
75 cm diameter.
25 cm diameter.

Correct Answer: 75 cm diameter.

← Previous Question Next Question→

More Questions from GATE Exam Questions

The following two statements are made with reference to the planar truss shown below The truss is statically determinate The truss is kinematically determinate With refernece to the above statements, which of the following applies?
The penetration test for bitumen is conduced at a temperature of
The net effective cross sectional area calculated in the steel angle tension member design, accounts for:
The equation along a stream line holds true for :
A three hinged arch shown in the below figur is quarter of a circle, If the vertical and horizontal components of reaction at A are equal, the value of θ is
The problem of lateral buckling can arise only in those steel beams which have
The BOD removal efficiency, in percentage, during primary treatmet under normal conditions is about
If a single pipe of length L and diameter D is to be replaced by three pipes of same material, same length and equal diameter d (d < D), to convey the same total discharge under the same head loss, then d and D are related by
The Piezometric head at point C, in the experimental set-up shown in the below figure when the flow takes place under a constant head through the soils A and B is
In an area of 200 hectare, water table drops by 4 m. If the porosity is 0.35 and the specific retention is 0.15, change in volume of storage in the aquifer is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion