Curioustab

Home » Civil Engineering » GATE Exam Questions

The net effective cross sectional area calculated in the steel angle tension member design, accounts for:

the tensile force and bolt holes
the eccentricity of the end connections and the bolt holes
the effectiveness of the tack connection along the length
the effectiveness of the end connection

Correct Answer: the tensile force and bolt holes

← Previous Question Next Question→

More Questions from GATE Exam Questions

The equation along a stream line holds true for :
A three hinged arch shown in the below figur is quarter of a circle, If the vertical and horizontal components of reaction at A are equal, the value of θ is
The problem of lateral buckling can arise only in those steel beams which have
The BOD removal efficiency, in percentage, during primary treatmet under normal conditions is about
If a single pipe of length L and diameter D is to be replaced by three pipes of same material, same length and equal diameter d (d < D), to convey the same total discharge under the same head loss, then d and D are related by
The Piezometric head at point C, in the experimental set-up shown in the below figure when the flow takes place under a constant head through the soils A and B is
In an area of 200 hectare, water table drops by 4 m. If the porosity is 0.35 and the specific retention is 0.15, change in volume of storage in the aquifer is
Generally (fatigue life of welded steel structure/fatigue life of riveted steel structure) ratio is,
Bending moments at joint b and c of the portal frame are respectively :
The effective width of a reinforced concrete T beam flange under compression, according to IS : 456-1978, given I0 is the distance between the adjacent zero moment points, b is the breadth of the rib and D is the thickness of the flange, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion