Curioustab

Home » Civil Engineering » GATE Exam Questions

A hydraulic turbine has a discharge of 5 m3/s, when operating under a head of 20 m with a speed of 500 rpm. If it is to operate under a head of 15 m, for the same discharge, the rotational speed in rpm will approximately be

433
403
627
388

Correct Answer: 433

← Previous Question Next Question→

More Questions from GATE Exam Questions

Lysimeter and Tensiometer are used to measure respectively, one of the following groups of quantities :
A single rapid test to determine the pollu-tional status of river water is :
The 5-day BOD of a wastewater sample is obtained as 190 mg/l (with k = 0.01 h-1). The ultimate oxygen demand (mg/l) of the sample will be
The reaction time for calculation of stopping distance may be assumed as
The percentage error in the computed discharge over a triangular notch corresponding to an error of 1% in the measurement of the head over the notch, would be
A hydraulic turbine develops a power of 104 metric horse power while running at a speed of 100 revolutions per minute, under a head of 40 m. Its specific speed is nearest to one of the following :
A 40° slope is excavated to a depth of 10 m in a deep layer of saturated clay of unit weight 20 kN.m3; the relevant shear strength parameters are cu = 70 kN/m2 and φu = 0. The rock ledge is at a great depth. The Taylor's stability coefficient for φu = 0 and 40° slope angle is 0.18. The factor of safety of the slope is :
In a compaction test, as the compaction effort is increased, the optimum moisture content
The number of simultaneous equations to be solved in the slope deflection method, is equal to :
The cylinder strength of the concrete is less than the cube strength because of

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion