Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
GATE Exam Questions
The force in the member DE of the truss shown in the below figure is,
100.0 kN
zero
35.5 kN
25.0 kN
Correct Answer:
zero
← Previous Question
Next Question→
More Questions from
GATE Exam Questions
A pile of 0.50 m diameter and of length 10 m is embedded in a deposit of clay. The un-drained strength parameters of the clay are cohesion = 60 kN/m2 and the angle in internal friction = 0. The skin friction capacity (kN) of the pile for an adhesion factor of 0.6, is
Two primary air pollutants are
Muskingum method for routing of flood
In a section, shear centre is a point through which, if the resultant load passes, the section will not be subjected to any
The total active thrust on a vertical wall 3m high retaining a horizontal sand backfill (unit weight γt = 20 kN/m3, angle of shearing resistance φ' = 30°) when the water table is at the bottom of the wall, will be:
A frame ABCD is supported by a roller at A and is on a hinge at C as shown below The reaction at the roller end A is given by
A cantilever beam is shown in the below figure. The moment to be applied at free end for zero vertical deflection at that point is
Standard 5-day BOD of a waste water sample is nearly x% of the ultimate BOD, where x is
A vertical rod PQ of length L is fixed at its top end P and has a flange fixed to the bottom end Q. A weight W is dropped vertically from a height h(< L) on to the flange. The axial stress in the rod can be reduced by
Which one of the following conditions, both elastic and plastic methods of analysis of indeterminate structures have to satisfy?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments