Curioustab

Home » Civil Engineering » GATE Exam Questions

A cantilever beam of length L and a cross section with shape factor f supports a concentrated load P as shown below The length LP of the plastic zone, when the maximum bending moment equals the plastic moment MP, given by

Correct Answer:

← Previous Question Next Question→

More Questions from GATE Exam Questions

For the frame shown in the below figure, the maximum bending moment in the column is,
Flexible pavements derive stability primarily from :
The capacities of "One-way 1.5 m wide sidewalk (persons per hour)" and "One-way 2-lane urban road (PCU per hour, with no frontage access, no standing vehicles and very little cross traffic)" are respectively.
Maximum size of a fillet weld for a plate of square edge is
Is 459-1978 recommends to provide certain minimum steel in a RCC beam
A hydraulic turbine has a discharge of 5 m3/s, when operating under a head of 20 m with a speed of 500 rpm. If it is to operate under a head of 15 m, for the same discharge, the rotational speed in rpm will approximately be
Lysimeter and Tensiometer are used to measure respectively, one of the following groups of quantities :
A single rapid test to determine the pollu-tional status of river water is :
The 5-day BOD of a wastewater sample is obtained as 190 mg/l (with k = 0.01 h-1). The ultimate oxygen demand (mg/l) of the sample will be
The reaction time for calculation of stopping distance may be assumed as

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion