Curioustab

Home » Civil Engineering » Applied Mechanics

Engineer's units of force, is

Newton in absolute units
Dyne in absolute units
Newton and dyne in absolute units
All the above.

Correct Answer: Newton in absolute units

← Previous Question Next Question→

More Questions from Applied Mechanics

To attain the synchronous orbit, the launch of a satellite, is done from a place
The tension in a cable supporting a lift
The angle which an inclined surface makes with the horiontal when a body placed on it is on the point of moving down, is called
The Law of Polygon of Forces states that
If three rigid rods are hinged together to form a triangle and are given rotary as well as translatory motion, the number of instantaneous centres of the triangle, will be
The masses of two balls are in the ratio of 2 : 1 and their respective velocities are in the ratio of 1 : 2 but in opposite direction before impact. If the coefficient of restitution is , the velocities of separation of the balls will be equal to
A string of length 90 cm is fastened to two points A and B at the same level 60 cm apart. A ring weighing 120 g is slided on the string. A horizontal force P is applied to the ring such that it is in equilibrium vertically below B. The value of P is :
The maximum velocity of a body vibrating with a simple harmonic motion of amplitude 150 mm and frequency 2 vibrations/sec, is
The reaction at the support A of the beam shown in below figure is
The centre of gravity of a triangle is at the point where three

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion