Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
The LMTD correction factor (FT) is defined as the
ratio of true temperature difference to the LMTD.
ratio of LMTD to the true temperature difference.
differenced of true temperature difference and the LMTD.
geometric mean of the true temperature difference and the LMTD.
Correct Answer:
ratio of true temperature difference to the LMTD.
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
The clearance between two tubes in a shell and tube heat exchanger is known as 'ligament', whose minimum value is __________ the outside diameter of the tube, but in no case it should be less than 4.5 mm.
Stage efficiency for packed tower varies with the
The raio, is normally taken as
The ratio of the largest load in a test to the original cross-sectional area of the test specimen is called the __________ stress.
In a shell and tube heat exchanger, the shortest centre to centre distance between the adjacent tubes is
A certain pressure vessel manufacturer avoids doing reinforcements calculations for openings by always providing a reinforcing pad extending upto double the diameter of the opening and of the same material and thickness as that of the shell wall. If area compensation is accepted as a code guideline, his approach leads to safe design
Poisson's ratio of a material is the ratio of unit lateral strain to the unit axial elongation within its elastic limit. The value of Poisson's ratio for structural and pressure vessel steel may be taken as
In a multipass shell and tube heat exchanger, the problem of differential expansion between the shell and tube passes is taken care of by using a
In a vertical short tube evaporator (Calendria type), the
Liquid redistribution should be done in a packed tower packed with raschig rings every 6 metres or __________ times the column diameter, whichever is lower.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments