Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

Minimum baffle spacing recommended in a shell and tube heat exchanger is equal to

5 cms
40% of the I.D. of the shell
25 cms
I.D. of the shell

Correct Answer: 5 cms

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

The units of Young's modulus of elasticity and __________ are the same.
The ratio of tube length to shell diameter in case of liquid shell and tube heat exchanger ranges from
The ratio for the rate of washing to the final rate of filtration in a washing type of plate and frame filter is
A/an __________ is used for changing the direction of a pipeline.
Value of Peclet number = 0, is the representative of
Typical static submergence for bubble cap plate column operating at atmospheric pressure may be around
For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3 μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)
To avoid the tearing off the plate of an edge, the margin (i.e., the minimum distance from the centre of the rivet hole to the nearest edge of the plate) should be equal to
In the allocated cap area, bubble caps are generally arranged on equilateral triangular pitch. Number of caps fixed on a plate is with a
Heat transfer co-efficient for a horizontal condenser as compared to a vertical condenser operating under similar conditions is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion