Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
If 'D' is the inside diameter of the shell of a shell and tube heat exchanger, then the baffle spacing is usually in the range of
D/2 or minimum 2" to 5D.
D/5 or minimum 2" to 5D.
D/5 or minimum 2" to D.
none of these.
Correct Answer:
D/5 or minimum 2" to 5D.
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
Weep holes provided in the plates of a distillation column
for a Tee (used as elbow, entering branch) would be
Tube wall thickness depends on the cor-rosiveness of the fluids and their operating pressure & temperature and is specified by Birmingham wire gauge (B.W.G)-a number which varies from 8 to 18 with the numbers 14 and 16 being more commonly used. Outside diameter of tubes varies from about 15 to 50 mm; however a tube of less than __________ mm outside diameter is generally not recommended for fouling fluids.
In actual operation of distillation column, the vapour is not distributed uniformly among the bubble caps, primarily because of the
Brass valves are usually made for pipe sizes __________ inches.
Low pressure steam (with saturation temperature between 105 to 120°C) is usually used in the vacuum evaporators, which normally employ a vacuum of about __________ mm Hg (referred to a 760 mm mercury barometer).
High pressure fluid in a shell and tube heat exchanger should preferably be routed through the
The LMTD correction factor (FT) is applied in __________ heat exchangers.
The minimum shell thickness for tank ≤ 15 metres diameter is limited to __________ mm, for reasons of elastic stability.
In a shell and tube heat exchanger, the clearance of the tube is generally
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments