Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
for a Tee (used as elbow, entering branch) would be
less than that for Tee (used as elbow, entering run).
more than that for Tee (used as elbow, entering run).
around 90.
both (b) and (c).
Correct Answer:
both (b) and (c).
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
Tube wall thickness depends on the cor-rosiveness of the fluids and their operating pressure & temperature and is specified by Birmingham wire gauge (B.W.G)-a number which varies from 8 to 18 with the numbers 14 and 16 being more commonly used. Outside diameter of tubes varies from about 15 to 50 mm; however a tube of less than __________ mm outside diameter is generally not recommended for fouling fluids.
In actual operation of distillation column, the vapour is not distributed uniformly among the bubble caps, primarily because of the
Brass valves are usually made for pipe sizes __________ inches.
Low pressure steam (with saturation temperature between 105 to 120°C) is usually used in the vacuum evaporators, which normally employ a vacuum of about __________ mm Hg (referred to a 760 mm mercury barometer).
High pressure fluid in a shell and tube heat exchanger should preferably be routed through the
The LMTD correction factor (FT) is applied in __________ heat exchangers.
The minimum shell thickness for tank ≤ 15 metres diameter is limited to __________ mm, for reasons of elastic stability.
In a shell and tube heat exchanger, the clearance of the tube is generally
For annular flow of a fluid, the ratio of the equivalent diameter for pressure drop calculation to the equivalent diameter for heat transfer calculation is
In a shell and tube heat exchanger, the overall heat transfer co-efficient is proportional to the tube side (volumetric flow rate)0.8. This is valid, only when the ratio of the tube side film resistance to the total resistance is almost equal to
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments