Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
Low pressure steam (with saturation temperature between 105 to 120°C) is usually used in the vacuum evaporators, which normally employ a vacuum of about __________ mm Hg (referred to a 760 mm mercury barometer).
250
450
650
750
Correct Answer:
650
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
High pressure fluid in a shell and tube heat exchanger should preferably be routed through the
The LMTD correction factor (FT) is applied in __________ heat exchangers.
The minimum shell thickness for tank ≤ 15 metres diameter is limited to __________ mm, for reasons of elastic stability.
In a shell and tube heat exchanger, the clearance of the tube is generally
For annular flow of a fluid, the ratio of the equivalent diameter for pressure drop calculation to the equivalent diameter for heat transfer calculation is
In a shell and tube heat exchanger, the overall heat transfer co-efficient is proportional to the tube side (volumetric flow rate)0.8. This is valid, only when the ratio of the tube side film resistance to the total resistance is almost equal to
Pick out the wrong statement pertaining to the design of a horizontal tube evaporator.
For a cylindrical shell, (subject to the thickness of uppermost course being more than the minimum for diaofthe tank in question), the thickness of the courses of shell
Maximum acceptable total liquid gradient over a tray is about __________ mm.
The dust collection efficiency of a cyclone separator
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments