Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

The distance between the top of the slots and the liquid surface when the static liquid is just ready to flow over the overflow weir is called

downcomer liquid seal
static submergence
skirt clearance
none of these

Correct Answer: static submergence

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

The approximate liquid depth in an agitation tank is equal to (where, d = tank diameter)
For given number of passes, pitch & tube diameter, the maximum number of tubes that can be accommodated in a shell of tripled inside diameter will be __________ times.
A binary liquid azeotropic mixture has boiling point lower than either of the components, when it shows __________ deviation from Raoult's Law.
Baffle width is normally taken as __________ times the tank diameter.
The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area 'A' is given by (where, P = perimeter of the channel in contact with the fluid)
Larger depth of liquid on the trays of a distillation column
Pressure drop per tray in the atmospheric distillation column is about __________ psi.
The centre to centre distance between two consecutive baffles in a shell and tube heat exchanger is called the baffle pitch or baffle spacing, which is more than 1/5th the I.D. of the shell. Which of the following is not a function of the baffles?
If a single tube pass heat exchanger is converted to two passes; for the same flow rate, the pressure drop per unit length in tube side will __________ times.
In the downcomer of a distillation column, the minimum recommended residence time is about __________ seconds.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion