Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

Baffle width is normally taken as __________ times the tank diameter.

0.1-0.12
0.4-0.5
0.45-0.6
0.2-0.45

Correct Answer: 0.1-0.12

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area 'A' is given by (where, P = perimeter of the channel in contact with the fluid)
Larger depth of liquid on the trays of a distillation column
Pressure drop per tray in the atmospheric distillation column is about __________ psi.
The centre to centre distance between two consecutive baffles in a shell and tube heat exchanger is called the baffle pitch or baffle spacing, which is more than 1/5th the I.D. of the shell. Which of the following is not a function of the baffles?
If a single tube pass heat exchanger is converted to two passes; for the same flow rate, the pressure drop per unit length in tube side will __________ times.
In the downcomer of a distillation column, the minimum recommended residence time is about __________ seconds.
Bubble cap plate column is
In case of 1.5" heat exchanger tubes, the inside flow area __________ with decrease in BWG.
For turbine agitator, the impeller diameter is about
Which tube arrangement in a heat exchanger would facilitate highest heat transfer rate?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion