for a Tee (used as elbow, entering run) would be around

More Questions from Process Equipment and Plant Design

• A minimum clearance of about __________ mm is maintained between the distillation column wall and the bubble cap.
• The distance between the centre of a rivet hole to the nearest edge of the plate is called
• Vertical storage vessels are never supported by __________ support.
• Power required for agitation depends upon the
• Wind load consideration in the design of a support can be neglected, when the vessel is
• Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always
• Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than __________ of the head.
• The ratio of lateral strain to linear strain is termed as the
• Frame thickness in the plate and frame filter press is normally in the range of __________ inches.
• In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)

Discussion & Comments