Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Biochemical Engineering
»
Downstream Processing
The purity of a solute collected between two times t1 and t2 during chromatographic separation can be calculated as
amount of solute eluted - amount of impurity eluted
amount of solute eluted / amount of impurity eluted
amount of solvent eluted + amount of impurity eluted
amount of solvent eluted / amount of impurity eluted
Correct Answer:
amount of solute eluted / amount of impurity eluted
← Previous Question
Next Question→
More Questions from
Downstream Processing
Start up expenses in a fermentation industry varies from
Selectivity can be expressed as
Concentration polarization can be reduced further by
The solvent flux across the membrane can be expressed as (where A is the area, Lp is the membrane permeability, σ is the reflection point, Δp is applied pressure and Δπ is the osmotic pressure)
A typical tubular centrifuge has a bowl of 2 to 5 inch in diameter and 9 to 30 inch in height with a maximum rotating speed of
The disk centrifuge is the type of centrifuge used most often for bio separations due to its
Which of the following is not the physical method for the cells rupturing?
The optimum wet solid content for the cell suspension for a bead mill is typically somewhere between
The effectiveness of a solvent can be measured by the
A system which require less solvent and produces a more concentrated extract phase, is desired with a
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments