Which command displays RIP routing updates?

Show ip route
debug ip rip
show protocols
Debug ip route

Correct Answer: debug ip rip

Explanation:

Debug ip rip is used to show the internet Protocol (IP) Routng Information protocol (RIP) updates being sent and received on the router.

More Questions from CISCO Certification

What metric does RIPv2 use to find the best path to a remote network?
Two connected routers are configured only with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?
When a PC sends a packet to another PC in a remote network, what destination IP address and MAC address will be in the frame that it sends to its default gateway?
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
What is the administrative distance of OSPF?
With which network type will OSPF establish router adjacencies but not perform the DR/BDR election process?
You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information?
A network administrator needs to configure a router with a distance-vector protocol that allows classless routing. Which of the following satisfies those requirements?
You get a call from a network administrator who tells you that he typed the following into his router: Router (config) #router ospf 1 Router (config-router) # network 10.0.0.0. 255. 0.0.0 area 0 He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?
Where are EIGRP successor routes stored?

Discussion & Comments

No comments yet. Be the first to comment!