Curioustab

Home » Technical Drawing » Sectional Views

When a cutting plane line would obscure important details, just the ends of the line outside the view and the arrows can be shown.

True

Correct Answer: True

← Previous Question Next Question→

More Questions from Sectional Views

It is not acceptable to use the general-purpose symbol at different angles for different parts.
In AutoCAD the Hatch tool is used to designate what pattern is to be used for a section view.
The Cutting Plane line should be displayed at the same line weight as object lines.
One of the outcomes of using section views in a technical drawing is the elimination of hidden lines.
When a part is cut fully in half, the resulting view is called a half section.
The ANSI 131 hatch pattern is the AutoCAD default hatch pattern.
The section lines in all hatched areas for an object must be parallel.
The Cutting Plane line reveals the type of material that the object is to be made from.
Omit hidden lines from both halves of a half section whenever possible.
If you set the ANSI 131 hatch pattern to an angle of 45 degrees the lines will be placed vertically.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion