Omit hidden lines from both halves of a half section whenever possible.

More Questions from Sectional Views

• If you set the ANSI 131 hatch pattern to an angle of 45 degrees the lines will be placed vertically.
• A section-lined area is always completely bounded by a visible outline.
• Removed sections should be labeled and arranged in order from right to left.
• Quarter sections expose the interior of one half of the object and the exterior of the other half.
• The preferred cutting plane line style is made up of equal dashes ending in arrowheads.
• The angle of revolution should always be less than 45 degrees for an aligned section.
• In offset sections, the bends in the cutting plane are typically shown in the sectional view.
• The visible edges of the object behind the cutting plane are not cross-hatched.
• The arrow points on either end of a Cutting Plane line indicate the direction of view.
• Section views cannot replace the normal top, front, side, or other standard orthographic views.

Discussion & Comments