Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Sectional Views
The preferred cutting plane line style is made up of equal dashes ending in arrowheads.
True
Correct Answer:
True
← Previous Question
Next Question→
More Questions from
Sectional Views
The angle of revolution should always be less than 45 degrees for an aligned section.
In offset sections, the bends in the cutting plane are typically shown in the sectional view.
The visible edges of the object behind the cutting plane are not cross-hatched.
The arrow points on either end of a Cutting Plane line indicate the direction of view.
Section views cannot replace the normal top, front, side, or other standard orthographic views.
Hidden lines are typically included in section views.
The cutting plane is shown in a view adjacent to the sectional view.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments