Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Dimensioning
When extension lines or centerlines cross visible object lines, gaps should not be left in the lines.
True
Correct Answer:
True
← Previous Question
Next Question→
More Questions from
Dimensioning
Where the decimal-inch dimension is used, a zero is not used before the decimal point of values less than 1.
The inch is the commonly used unit for most metric engineering drawings.
It is more difficult to manufacture a part designed using two decimal places than the same part using four decimal places.
Longer dimension lines are nearest the object outline.
Avoid dimensioning to hidden lines.
Most mechanical drawings will include tolerance information in or near the drawing title block.
Typically, all dimension values and notes are lettered horizontally and should read from the bottom of the sheet.
A set of two mutually perpendicular datum planes is required for coordinate dimensioning.
When a finished part is measured, it may vary slightly from the exact dimension specified.
The American Society of Mechanical Engineers provides a set of common standards used by industry for placement of dimensions.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments