Curioustab

Home » Technical Drawing » Dimensioning

It is more difficult to manufacture a part designed using two decimal places than the same part using four decimal places.

True

Correct Answer: False

← Previous Question Next Question→

More Questions from Dimensioning

Longer dimension lines are nearest the object outline.
Avoid dimensioning to hidden lines.
Most mechanical drawings will include tolerance information in or near the drawing title block.
Typically, all dimension values and notes are lettered horizontally and should read from the bottom of the sheet.
A set of two mutually perpendicular datum planes is required for coordinate dimensioning.
When a finished part is measured, it may vary slightly from the exact dimension specified.
The American Society of Mechanical Engineers provides a set of common standards used by industry for placement of dimensions.
Fillet radii can be given in a general note.
It is permissible to letter a dimension value over any line on the drawing.
Although an engineer has placed dimensions in specific locations the drafter has the freedom to arrange them as he deems necessary.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion