Dimensioning problems
- 1. Placement of dimensions on a drawing is controlled by ________.
Options- A. ANSI
- B. The design engineer
- C. Corporate drafting standards
- D. All of the above Discuss
Correct Answer: All of the above
- 2. The ________ dimension tool will place the length of an angled line.
Options- A. Aligned
- B. Angle
- C. Linear
- D. Radial Discuss
Correct Answer: Aligned
- 3. In this type of dimensioning, allowance must be made for bends:
Options- A. Angular
- B. Tolerance
- C. Datum
- D. Sheet metal Discuss
Correct Answer: Sheet metal
- 4. In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches:
Options- A. One inch or over
- B. One foot or over
- C. One yard or over
- D. One rod or over Discuss
Correct Answer: One foot or over
- 5. Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?
Options- A. Use the Modify tool to clean up the extension lines.
- B. Use the Tolerance tool to clean up the extension lines.
- C. Use the Break tool to clean up the extension lines.
- D. Use the stretch tool to clean up the extension lines. Discuss
Correct Answer: Use the Modify tool to clean up the extension lines.
- 6. How can the drafter prevent AutoCAD from placing or stacking another center mark on a circle when adding a diameter dimension to it?
Options- A. Explode the dimension and then erase the center mark.
- B. Use the Properties dialog box to turn off the center mark of the dimension.
- C. It can't be done.
- D. Use the trim tool to take away the stacked center mark. Discuss
Correct Answer: Use the Properties dialog box to turn off the center mark of the dimension.
- 7. The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.
Options- A. Linear
- B. Continue
- C. Baseline
- D. Quick Dimension Discuss
Correct Answer: Quick Dimension
- 8. It is always acceptable to dimension to a hidden feature.
Options- A. True
- B. False Discuss
Correct Answer: False
- 9. An external cylindrical shape is dimensioned where it appears circular.
Options- A. True
- B. False Discuss
Correct Answer: False
- 10. Tolerance issues are primarily a concern in manufacturing rather than in the design and drafting process.
Options- A. True
- B. False Discuss
Correct Answer: False
More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.