Production Engineering problems
- 1. A drill considered as a cutting tool having zero rake, is known as a
Options- A. flat drill
- B. straight fluted drill
- C. parallel shank twist drill
- D. tapered shank twist drill Discuss
Correct Answer: straight fluted drill
- 2. Segmental chips are formed during machining
Options- A. mild steel
- B. cast iron
- C. high speed steel
- D. high carbon steel Discuss
Correct Answer: cast iron
- 3. The velocity of tool relative to the workpiece is known as cutting velocity.
Options- A. True
- B. False Discuss
Correct Answer: True
- 4. The average cutting speed for turning brass with a high speed steel tool is
Options- A. 15 to 19 m/min
- B. 25 to 31 m/min
- C. 60 to 90 m/min
- D. 90 to 120 m/min Discuss
Correct Answer: 60 to 90 m/min
- 5. Twist drills are made of
Options- A. high speed steel
- B. carbon steel
- C. stainless steel
- D. either (a) or (b) Discuss
Correct Answer: either (a) or (b)
- 6. The maximum production of small and slender parts is done by
Options- A. watch maker's lathe
- B. sliding head stock automatic lathe
- C. multispindle automatic lathe
- D. capastan lathe Discuss
Correct Answer: multispindle automatic lathe
- 7. A push broach as compared to pull broach
Options- A. has less number of teeth
- B. is short and stocky
- C. removes less material for each pass of the tool
- D. all of the above Discuss
Correct Answer: all of the above
- 8. In oblique cutting system, the maximum chip thickness occurs at the middle.
Options- A. Correct
- B. Incorrect Discuss
Correct Answer: Incorrect
- 9. A fixture is defined as a device which
Options- A. holds and locates a workpiece and guides and controls one or more cutting tools
- B. holds and locates a workpiece during an inspection or for a manufacturing operation
- C. is used to check the accuracy of workpiece
- D. all of the above Discuss
Correct Answer: holds and locates a workpiece during an inspection or for a manufacturing operation
- 10. A round nose tool may be fed eitner from left to right end or from right to left end of the lathe bed.
Options- A. Yes
- B. No Discuss
Correct Answer: Yes
More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.