Production Engineering problems
- 1. Side relief angle of a single point tool is the angle
Options- A. by which the face of the tool is inclined towards back
- B. by which the face of the tool is inclined sideways
- C. between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool
- D. between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base Discuss
Correct Answer: between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool
- 2. To grind brittle materials, a coarse grained grinding wheel is used.
Options- A. Agree
- B. Disagree Discuss
Correct Answer: Disagree
- 3. The actual feed in centreless grinders is given by (where d = Dia. of regulating wheel, n = Revolutions per minute, and ? = Angle of inclination of wheel)
Options- A. ?d
- B. ?d n
- C. ?d n sin ?
- D. ?d n cos ? Discuss
Correct Answer: ?d n sin ?
- 4. In a single point turning operation with a cemented carbide and steel combination having a Taylor exponent of 0.25, if the cutting speed is halved, then tool life will become
Options- A. half
- B. two times
- C. eight times
- D. sixteen times Discuss
Correct Answer: sixteen times
- 5. Gears can be best produced on mass production by
Options- A. shaping
- B. casting
- C. forming
- D. hobbing Discuss
Correct Answer: hobbing
- 6. Gears can be cut on a shaper.
Options- A. Agree
- B. Disagree Discuss
Correct Answer: Agree
- 7. Jigs are used
Options- A. for holding and guiding the tool in drilling, reaming or tapping operations
- B. for holding the work in milling, grinding, planing or turning operations
- C. to check the accuracy of workpiece
- D. none of the above Discuss
Correct Answer: for holding and guiding the tool in drilling, reaming or tapping operations
- 8. The hole to be drilled for tapping is __________ the outside diameter of the thread on the tap.
Options- A. equal to
- B. smaller than
- C. greater than Discuss
Correct Answer: smaller than
- 9. Dielectric is used in
Options- A. electro-chemical machining
- B. ultra-sonic machining
- C. electro-discharge machining
- D. laser machining Discuss
Correct Answer: electro-discharge machining
- 10. The size of a lathe is specified by the
Options- A. length between centres
- B. swing diameter over the bed
- C. swing diameter over the carriage
- D. all of these Discuss
Correct Answer: all of these
More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.