Heat Transfer, Refrigeration and Air Conditioning problems
- 1. The horizontal and non-uniformly spaced lines on a psychrometric chart indicates
Options- A. dry bulb temperature
- B. wet bulb temperature
- C. dew point temperature
- D. specific humidity Discuss
Correct Answer: dew point temperature
- 2. In order to cool and dehumidify a stream of moist air, it must be passed over the coil at a temperature
Options- A. which lies between the dry bulb and wet bulb temperatures of the incoming stream
- B. which lies between the wet bulb and dew point temperatures of the incoming stream
- C. which is lower than the dew point temperature of the incoming stream
- D. of adiabatic saturation of incoming stream Discuss
Correct Answer: which is lower than the dew point temperature of the incoming stream
- 3. Which of the following refrigerant is highly toxic and flammable?
Options- A. Ammonia
- B. Carbon dioxide
- C. Sulphur dioxide
- D. R-12 Discuss
Correct Answer: Ammonia
- 4. The most commonly used method for the design of duct size is the
Options- A. velocity reduction method
- B. equal friction method
- C. static regain method
- D. dual or double method Discuss
Correct Answer: static regain method
- 5. The undesireable property of a refrigerant is
Options- A. non-toxic
- B. non-flammable
- C. non-explosive
- D. high boiling point Discuss
Correct Answer: high boiling point
- 6. The expression Q = ? AT4 is called
Options- A. Fourier equation
- B. Stefan-Boltzmann equation
- C. Newton-Rikhmann equation
- D. Joseph-Stefan equation Discuss
Correct Answer: Stefan-Boltzmann equation
- 7. In actual air-conditioning applications for R-12 and R-22, and operating at a condenser temperature of 40° C and an evaporator temperature of 5° C, the heat rejection factor is about
Options- A. 1
- B. 1.25
- C. 2.15
- D. 5.12 Discuss
Correct Answer: 1.25
- 8. The heating of air, without any change in its specific humidity, is known as sensible heating.
Options- A. True
- B. False Discuss
Correct Answer: True
- 9. In counter-current flow heat exchangers
Options- A. both the fluids at inlet are in their hottest state
- B. both the fluids at inlet are in their coldest state
- C. both the fluids at exit are in their hottest state
- D. one fluid is coldest and the other is hottest at inlet Discuss
Correct Answer: both the fluids at inlet are in their hottest state
- 10. In a refrigeration system, the expansion device is connected between the
Options- A. compressor and condenser
- B. condenser and receiver
- C. receiver and evaporator
- D. evaporator and compressor Discuss
Correct Answer: receiver and evaporator
More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.