CuriousTab
Search
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Building Construction problems
1. The least bearing capacity of soil is that of
Options
A. hard rock
B. moist clay
C. soft rock
D. laminated
E. coarse sandy soil.
Show Answer
Scratch Pad
Discuss
Correct Answer: moist clay
2. The nominal thickness of an expansion joint in brick walls, is kept more than
Options
A. 5 mm
B. 10 mm
C. 15 mm
D. 20 mm
E. 40 mm.
Show Answer
Scratch Pad
Discuss
Correct Answer: 20 mm
3. The vertical members fixed between steps and hand rail, are known
Options
A. balusters
B. strings
C. newel posts
D. soffits.
Show Answer
Scratch Pad
Discuss
Correct Answer: balusters
4. In flat roof of reinforced cement concrete, the recommended angle of slope, is
Options
A. zero
B. a few degrees
C. 10°
D. 200°.
Show Answer
Scratch Pad
Discuss
Correct Answer: a few degrees
5. The arrangement made to support an unsafe structure temporarily, is known as
Options
A. shoring
B. scaffolding
C. underpinning
D. jacking
E. none of these.
Show Answer
Scratch Pad
Discuss
Correct Answer: shoring
6. Pick up the correct statement from the following :
Options
A. English bond is used for brick masonry to support heavy loads
B. Double-flemish bond is suitable for brick masonry to give uniform face appearance
C. The double-flemish bond is used for the construction of single brick residential building
D. The stretcher bond is used for the construction of half brick masonry brick
E. all the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: all the above.
7. Pick up the correct statement from the following :
Options
A. Cavity of a cavity wall should start near ground level
B. Cavity of a cavity wall should terminate near eaves level of sloping roof
C. Cavity of a cavity wall should terminate near coping of flat roof with parapet wall
D. Damp proof course for two leaves of a cavity wall, is laid separately but at the same level
E. All the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: All the above.
8. The type of pointing in which upper side of mortar joints is kept about 12 mm inside the face of the masonry and bottom is kept flushed with face of wall, is
Options
A. truck pointing
B. recessed pointing
C. struck pointing
D. grooved pointing.
Show Answer
Scratch Pad
Discuss
Correct Answer: struck pointing
9. For plastering the exposed brick walls, the cement sand mortar should be
Options
A. 1:2
B. 1:3
C. 1:4
D. 1:6
E. 1:8.
Show Answer
Scratch Pad
Discuss
Correct Answer: 1:4
10. An arch may fail due to
Options
A. uneven settlement of abutments
B. sliding of voussoirs
C. crushing of the material
D. all the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: all the above.
First
17
18
19
...
20
..
22
23
Last
More in Civil Engineering:
Advanced Surveying
Airport Engineering
Applied Mechanics
Building Construction
Building Materials
Concrete Technology
Construction Management
Docks and Harbours
Elements of Remote Sensing
Engineering Economy
Estimating and Costing
GATE Exam Questions
Highway Engineering
Hydraulics
Irrigation
Railways
RCC Structures Design
SI Units
Soil Mechanics and Foundation Engineering
Steel Structure Design
Strength of Materials
Structural Design Specifications
Surveying
Theory of Structures
Tunnelling
UPSC Civil Service Exam Questions
Waste Water Engineering
Water Resources Engineering
Water Supply Engineering