Structural Drawing — Because surfacing (planing) removes material, the nominal size of structural timber is larger than its dressed (finished) thickness and width used on drawings and site measurements.

Introduction / Context:
Timber is often specified by nominal sizes (for example, 2x4), which refer to rough-sawn dimensions before planing. After surfacing (S4S), the dressed size is smaller (for example, about 1.5 in x 3.5 in). Drawings and structural calculations must reflect this reality to avoid fit and capacity issues.

Given Data / Assumptions:

• Boards and beams are surfaced to improve finish and dimensional consistency.
• Removal of material reduces cross-sectional dimensions.
• Design values and spans rely on actual (dressed) sizes.

Concept / Approach:
The distinction between nominal and actual dimensions is essential for bearing length, connector sizing, and section properties (area, I, S). Using nominal values in calculations overestimates capacity.

Step-by-Step Solution:
1) Identify nominal size (label).2) Convert to dressed size according to standards.3) Use dressed dimensions in structural checks and detailing.4) Coordinate callouts and schedules to avoid mismatches.

Verification / Alternative check:
Measure a sample surfaced member; the dressed size is consistently smaller than the nominal stamp.

Why Other Options Are Wrong:
Claiming equality or that dressed is larger contradicts basic manufacturing; paint does not change structural size.

Common Pitfalls:
Specifying connectors for nominal sizes; misaligning framing due to assuming nominal widths.

Final Answer:
Correct