Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Networking
»
Subnetting
On a VLSM network, which mask should you use on point-to-point WAN links in order to reduce the waste of IP addresses?
/27
/28
/29
/30
Correct Answer:
/30
Explanation:
A point-to-point link uses only two hosts. A /30, or 255.255.255.252, mask provides two hosts per subnet.
← Previous Question
Next Question→
More Questions from
Subnetting
Using the illustration from the previous question, what would be the IP address of S0 if you were using the first subnet? The network ID is 192.168.10.0/28 and you need to use the last available IP address in the range. Again, the zero subnet should not be considered valid for this question.
If a host on a network has the address 172.16.45.14/30, what is the subnetwork this host belongs to?
A network administrator is connecting hosts A and B directly through their Ethernet interfaces, as shown in the illustration. Ping attempts between the hosts are unsuccessful. What can be done to provide connectivity between the hosts? A crossover cable should be used in place of the straight-through cable. A rollover cable should be used in place of the straight-through cable. The subnet masks should be set to 255.255.255.192. A default gateway needs to be set on each host. The subnet masks should be set to 255.255.255.0.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments