Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Networking
»
Managing a Cisco Internetwork
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?
You must type the show ip rip command first.
IP addressing on the network is incorrect.
You must use the terminal monitor command.
Debug output is sent only to the console.
Correct Answer:
You must use the terminal monitor command.
Explanation:
To see console messages through your Telnet session, you must enter the
terminal monitor
command.
← Previous Question
Next Question→
More Questions from
Managing a Cisco Internetwork
Which command will copy the IOS to a backup host on your network?
Which command displays the configuration register setting?
The configuration register setting of 0x2102 provides what function to a router?
What should the configuration register value be after you successfully complete the password recovery procedure and return the router to normal operation?
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
What information is displayed by the show hosts command? Temporary DNS entries The names of the routers created using the hostname command The IP addresses of workstations allowed to access the router Permanent name-to-address mappings created using the ip host command The length of time a host has been connected to the router via Telnet
You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? TFTP server software must be running on the router. TFTP server software must be running on your laptop. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. The laptop must be on the same subnet as the router's Ethernet interface. The copy flash tftp command must be supplied the IP address of the laptop.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments