Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Networking
»
Managing a Cisco Internetwork
Which three commands can be used to check LAN connectivity problems on a router? show interfaces show ip route tracert ping dns lookups
1 ,2 and 4
2 and 5
3 and 5
None of the above
Correct Answer:
1 ,2 and 4
Explanation:
The
tracert
command is a Windows command and will not work on a router! A router uses the
traceroute
command.
← Previous Question
Next Question→
More Questions from
Managing a Cisco Internetwork
You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?
Which command will copy the IOS to a backup host on your network?
Which command displays the configuration register setting?
The configuration register setting of 0x2102 provides what function to a router?
What should the configuration register value be after you successfully complete the password recovery procedure and return the router to normal operation?
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
What information is displayed by the show hosts command? Temporary DNS entries The names of the routers created using the hostname command The IP addresses of workstations allowed to access the router Permanent name-to-address mappings created using the ip host command The length of time a host has been connected to the router via Telnet
You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? TFTP server software must be running on the router. TFTP server software must be running on your laptop. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. The laptop must be on the same subnet as the router's Ethernet interface. The copy flash tftp command must be supplied the IP address of the laptop.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments