Home » Networking » Managing a Cisco Internetwork

What should the configuration register value be after you successfully complete the password recovery procedure and return the router to normal operation?

0x2100
0x2101
0x2102
0x2142

Correct Answer: 0x2102

Explanation:

All Cisco routers have a default configuration register setting of 0x2102, which tells the router to load the IOS from flash memory and the configuration from NVRAM.

← Previous Question Next Question→

More Questions from Managing a Cisco Internetwork

You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
What information is displayed by the show hosts command? Temporary DNS entries The names of the routers created using the hostname command The IP addresses of workstations allowed to access the router Permanent name-to-address mappings created using the ip host command The length of time a host has been connected to the router via Telnet
You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? TFTP server software must be running on the router. TFTP server software must be running on your laptop. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. The laptop must be on the same subnet as the router's Ethernet interface. The copy flash tftp command must be supplied the IP address of the laptop.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion