Curioustab

Home » Networking » IOS and Security Device Manager

If you wanted administrators to see a message when logging into the router, which command would you use?

message banner motd
banner message motd
banner motd
message motd

Correct Answer: banner motd

Explanation:

The typical banner is a message of the day (MOTD) and is set by using the global configuration mode command banner motd.

← Previous Question Next Question→

More Questions from IOS and Security Device Manager

What layer of the OSI model would you assume the problem is in if you type show interface serial 1 and receive the following message? "Serial1 is down, line protocol is down."
You type the following command into the router and receive the following output: Router#show serial 0/0 ^ % Invalid input detected at '^' marker. Why was this error message displayed?
Which command will show you whether a DTE or a DCE cable is plugged into serial 0?
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface? show version show protocols show interfaces show controllers show ip interface
You want to totally reinitialize the router and replace the current running-config with the current startup-config. What command will you use?
You type show running-config and get this output: [output cut] Line console 0 Exec-timeout 1 35 Password CURIOUSTABPASSWD Login [output cut] What do the two numbers following the exec-timeout command mean?
Which of the following commands will configure all the default VTY ports on a router?
Which of the following commands displays the configurable parameters and statistics of all interfaces on a router?
What command do you type to save the configuration stored in RAM to NVRAM?
You type Router#sh ru and receive an % ambiguous command error. Why did you receive this message?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion