Curioustab

Which EIGRP information is held in RAM and maintained through the use of Hello and update packets? Neighbor table STP table Topology table DUAL table

2 only
4 only
1 and 3
All of the above

Correct Answer: 1 and 3

Explanation:

EIGRP holds three tables in RAM: neighbor, topology, and routing. The neighbor and topology tables are built and maintained with the use of Hello packets.

← Previous Question Next Question→

More Questions from EIGRP and OSPF

Your company is running IGRP using an AS of 10. You want to configure EIGRP on the network but want to migrate slowly to EIGRP and don't want to configure redistribution. What command would allow you to migrate over time to EIGRP without configuring redistribution?
Which two of the following commands will place network 10.2.3.0/24 into area 0? router eigrp 10 router ospf 10 network 10.0.0.0 network 10.2.3.0 0.0.0.255 area0 network 10.2.3.0 0.0.0.255 area 0
A network administrator needs to configure a router with a distance-vector protocol that allows classless routing. Which of the following satisfies those requirements?
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
Which of the following are true regarding OSPF areas? You must have separate loopback interfaces configured in each area. The numbers you can assign an area go up to 65,535. The backbone area is also called area 0. If your design is hierarchical, then you don't need multiple areas. All areas must connect to area 0.
Which of the following describe the process identifier that is used to run OSPF on a router? It is locally significant. It is globally significant. It is needed to identify a unique instance of an OSPF database. It is an optional parameter required only if multiple OSPF processes are running on the router.
Which type of OSPF network will elect a backup designated router? Broadcast multi-access Non-broadcast multi-access Point-to-point Broadcast multipoint
Where are EIGRP successor routes stored?
What are reasons for creating OSPF in a hierarchical design? To decrease routing overhead To speed up convergence To confine network instability to single areas of the network To make configuring OSPF easier
Which is true regarding EIGRP successor routes? A successor route is used by EIGRP to forward traffic to a destination. Successor routes are saved in the topology table to be used if the primary route fails. Successor routes are flagged as "active" in the routing table. A successor route may be backed up by a feasible successor route. Successor routes are stored in the neighbor table following the discovery process.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion