Curioustab

Home » Mechanical Engineering » Strength of Materials

Which of the following is a proper sequence?

proportional limit, elastic limit, yielding, failure
elastic limit, proportional limit, yielding, failure
yielding, proportional limit, elastic limit, failure
none of the above

Correct Answer: proportional limit, elastic limit, yielding, failure

← Previous Question Next Question→

More Questions from Strength of Materials

According to Unwin's formula, the relation between diameter of rivet hole (d) and thickness of plate (t) is given by (where d and t are in mm)
The bending moment diagram for a simply supported beam loaded in its centre is
A shear stress across a plane, is always accompanied by a balancing shear stress across the plane and normal to it.
The total strain energy stored in a body is called proof resilience.
In the below figure, curve D represents mild steel.
According to Euler's column theory, the crippling load of a column is given by p = π2 EI/Cl2. In the Euler's formula, the value of C for a column with one end fixed and the other end hinged, is 1/2.
The moment of resistance of a balanced reinforced concrete beam is based on the stresses in
The Rankine's constant for a mild steel column with both ends hinged is
The given figure shows the Mohr's circle of stress for two unequal and like principal stresses (σx and σy) acting at a body across two mutually perpendicular planes. The tangential stress is given by
Modulus of rigidity may be defined as the ratio of

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion