Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Home
»
Mechanical Engineering
»
Strength of Materials
Factor of safety is defined as the ratio of
ultimate stress to working stress
working stress to ultimate stress
breaking stress to ultimate stress
ultimate stress to breaking stress
Correct Answer:
ultimate stress to working stress
← Previous Question
Next Question→
More Questions from
Strength of Materials
The torsional rigidity of a shaft is expressed by the torque required to produce a twist of one radian per unit length of a shaft.
When a rectangular beam is loaded transversely, the maximum tensile stress is developed on the
For a given stress, the ratio of moment of resistance of a beam of square cross-section when placed with its two sides horizontal to the moment of resistance with its diagonal horizontal, is
A fixed beam is one which is fixed at __________ of its ends.
The relation between modulus of elasticity (E) and modulus of rigidity (C) is given by
The bending moment on a section is maximum where shear force is
When a bar is subjected to a change of temperature and its deformation is prevented, the stress induced in the bar is
Whenever some external system of forces acts on a body, it undergoes some deformation. As the body undergoes some deformation, it sets up some resistance to the deformation. This resistance per unit area to deformation, is called
The layer at the centre of gravity of the beam as shown in the below figure, will be
A simply supported beam 'A' of length l, breadth b and depth d carries a central point load W. Another bream 'B' has the same length and breadth but its depth is doubled. The deflection of beam 'B' will be double as compared to beam 'A'.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments