Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Home
»
Mechanical Engineering
»
Strength of Materials
In the below figure, the plastic range occurs
before point A
beyond point A
between points A and D
between points D and E
Correct Answer:
beyond point A
← Previous Question
Next Question→
More Questions from
Strength of Materials
The stiffness of a closely-coiled helical spring is __________ proportional to number of turns.
The ratio of maximum shear stress developed in a rectangular beam and a circular beam of the same cross-sectional area is
A beam of triangular section is placed with its base horizontal. The maximum shear stress occurs at
The shear stress at the centre of a circular shaft under torsion is
At the neutral axis of a beam, the shear stress is
The product of Young's modulus (E) and moment of inertia (I) is known as
The actual neutral axis of a reinforced cement concrete beam is based on the principle that the moment of areas of compression and tension zones at the neutral axis are equal.
A column of length (l) with both ends fixed may be considered as equivalent to a column of length __________ with one end fixed and the other end free.
If there is a fall in the temperature of a composite body, then a member having greater coefficient of linear expansion will be subjected to compressive stress.
The buckling load for a given column depends upon
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments